MICROSWISS MK10 All Metal Hotend FLASHFORGE Kit 0.4mm Düse, 39.50 CHF

Beschreibung
Bewertungen

Micro Swiss All Metal Hotend Kit for Flashforge Finder / Inventor 2 / Guider 2 / 2S / 0.4mm

This is an all metal hotend upgrade kit for Flashforge Finder and Flashforge Guider 2. All metal hotend will let you print at much higher temperature than possible with original PTFE lined one. Another benefit of an all metal hotend design is more consistent melt chamber control. During slow extrusion rate, in PTFE lined hotend, transition zone from solid to molten plastic tends to creep upward creating more stringy prints. With all metal design a transition zone is always constant, being located right at the heat break. With fast extrusion rate, PTFE tube doesn't have enough thermal conductivity to properly melt all the plastic coming out. All metal hotend solves this problem, plastic is surrounded by thermally conductive nozzle throughout its length.

nur MK10 All-Metall-Düsen verwenden: .2mm, .3mm, .4mm .5mm, .6mm, .8mm

Made in USA by Micro Swiss

Fits:

FlashForge Finder
FlashForge Inventor 2
FlashForge Guider 2 (Older version, without metal plate over the heater block)
FlashForge Guider 2S
Dremel 3D40 Idea Builder

Druckermodell:	Flashforge Finder Flashforge Guider 2/2s
Düsendurchmesser:	0.4mm
Hersteller:	Micro Swiss
Düsen Typ:	MK10
Düsenmaterial:	A2 INOX
Versandgewicht:	0.20 kg

Es gibt noch keine Bewertungen.

Kunden kauften dazu folgende Artikel:

FLASHFORGE Guider IIS Flexible Federstahl 3D-Druckoberfläche

65.50 CHF *

PRIMACREATOR MK10 Ruby Düse 0.4mm

63.50 CHF *