1. Preparation: Shake PrintaStick for a few seconds to mix the solution. Only apply on a cold residue free printbed. If necessary you can use PrintaClean to remove residue from the printbed.
AprintaPro PrintaStick 50ml
PrintaStick works with all materials and secures a strong bond to the buildplate until the 3D print is finished. The sponge applicator makes the usage of PrintaStick easy, precise and effortless. During application and printing PrintaStick does not release or produce any unpleasant smell and after the print is finished there is no visible trace of PrintaStick on the 3D print.
- Strong formula works for many materials
- precise to apply
- high temperature stable
- no unpleasant smell
- water washable
2. Apply PrintaStick by pressing the sponge applicator on the printbed to release some liquid. Then spread the liquid by moving the sponge in a circular pattern over the printbed. If the sponge hardens – rinse with clean water to soften.
3. Finish and Clean Up: Start the printing process with recommended temperature settings. The liquid will dry up during the heat up process of the printbed and leave a fine film that enables the connection to the 3D print. After your print has finished, wash off with water.
PrintaStick or PrintaFix
|Recommended for unheated printbeds||Yes||~|
|Recommended for heated printbeds||Yes||Yes|
|Precise to apply||~||Yes|
|Works with general materials: PLA, PET-G, M-ABS||Yes||Yes|
|Works with special materials WOOD, PURE, PET-G CF20, FLEX HARD; METAL, HIPS||Yes||Yes|
|Works with professional materials PA6, PA12, PC-ABS||~||Yes|
Customers who bought this product also bought the following products: