AprintaPro PrintaFix adhesive spray (500ml)
AprintaPro - powerful solutions for makers
PrintaFix - the best solution for adhesion problems in 3D printing, no warping anymore.
- easy to use –simple as Shake | Spray | Print!
- for non-heated and heated printbeds
- removable with warm water
- environmentally friendly
PrintaFix Basic is developed particularly for FDM/FFF 3D printing and is characterized by its ease of use, the low price per print (approx.. 11 cent per print) and excellent adhesion on non-heated and heated printbeds.
With PrintaFix you solve problems with the adhesion far better and more convenient that with other products.
Saftey Data Sheet
shake -spray - print
Take the printbed out of your 3D printer, shake PrintaFix well, apply overlapping circles on the printbed and start the print as usal. Warping and first layer problems is a thing of the past. Clean up is done in seconds. Just use warm water or an alcoholic window cleaner (must contain ethanol).
Recommended settings: PLA: printing temperature 200-215°C
ABS: printing temperature 235-250°C printbed temperature 80-100°C 5mm brim
You will get a smooth and nice finish on the bottom.
Multiple prints on one PrintaFix coating are possible (Adhesion drops about 20% per print depending on the size of the previous model.)
For extreme high adhesion: Spray PrintaFix as usual in overlapping circles on the printbed. Wait until it is dried. Then spray again a fine nebula with a few pumps from a distance of 30 cm on the printbed.
Customers who bought this product also bought the following products:
Our previous price
Now only 39.00 CHF
you save 21 % / 10.50 CHF